Reverse Bend Tester

Length and testing requirements will be set by you or your customer. The wire or strip being tested should be the straightest possible as to not sway any results.

A test piece that is not completely straight is going to impact your results. It is recommended to straighten your test pieces completely using either a wire straightener, or going the tried and true way of hammering on a level surface such as wood, plastic or copper, and a hammer of similar material. The hard part this way is ensuring the test piece isn't damaged or twisted!

Ensure that your test piece is placed properly in the guides, and grips, and you bend the piece completely 90° in each direction, each interval per your testing requirements.

One direction completely bent and back to its original position is considered one bend.

Repeat in the opposite direction without interruption

Sjogren stands out in the market with unparalleled quality. Our pricing is tailored to your specific production requirements.

We offer volume pricing discounts, sharing the savings from manufacturing larger quantities directly with you. Consider this for bulk orders of different sizes.

Depending on material costs, a RBT may cost generally under $20k, often much less. All Sjogren products come with Sjogren's quality assurance guarantee for life and comprehensive support for all your wire tooling and quality testing needs.

We offer a range of standardized guides to accommodate wire diameters from 0.012” – 0.394” (0,3mm-10mm) and metallic flat wire 0.118” (3mm) thick or less.